Bricklets

• 1-wire communication with any 1-wire capable device
• Offers high-level commands (bus search, reset, write, read, write command)
• Supports 3.3V, 5V and external supply voltage
• Supports up to 64 1-wire devices simultaneously

• Receives data from outdoor weather station and indoor sensors
• Measures Temperature, Humidity, Wind/Gust speed, Wind direction and Rainfall
• Can use up to 255 weather stations/sensors simultaneously

• Measures Particulate Matter concentration
• Measures in µg/m³ for differenz sizes
• Distinguishable particle sizes: PM1.0, PM2.5 and PM10
• Integrated fan for air flow

• Controls one brushed DC motor with max. 36V and 10A (continuously)
• Direction, velocity and acceleration controllable
• Two configurable opto-coupled GPIOs for end-stops or similar
• Status, error, direction and GPIO LEDs
• Configurable overtemperature and overcurrent callbacks

• Can beep with configurable frequency of 50Hz to 15000Hz
• Can output fully configurable alarm/siren sound
• Loudness configurable between 85dB(A) and 110dB(A)

• Battery-backed real-time clock
• Hundredth of a second time resolution
• Low power consumption in battery mode

• Wireless house automation
• Controls remote mains switches (supported devices)
• Can control remote mains switches with dimming function
• Can read out the remotes of remote mains switches

• 1x RGB LED
• 24 bit color resolution
• Luminance output is corrected for human light perception (CIE 1931)

• High quality 15mm x 15mm button
• Adjustable RGB LED backlight
• Replacable/user-printable cap inlay

• 360° rotary encoder
• Counts 24 steps per rotation (step angle 15°)
• Integrated push-button

• 300° rotary potentiometer
• Outputs position from -150° to 150° in 1° steps

• Sends and receives serial data
• Provides RS-232 and UART-TTL interface
• Configurable baudrate, parity, stop bits, word length and flow control

• Supports low-level RS485 as well as Modbus RTU master/slave
• Modbus RTU implementation is fully compliant for reading and writing of coils and registers
• Supports full- and half-duplex
• Configurable baudrate, parity, stop bits and word length
• Switchable 120 Ohm termination

• Four 7-segment digits
• Switchable dots per digit, colon and tick mark
• Brightness of segments configurable
• Configurable counter functionality

• Controls up to 10 RC Servos
• Brushless motors with external ESC also controllable
• Adjustable Period and pulse width
• Uses motion planning to reach position with smooth motion
• Velocity and acceleration/deceleration can be configured
• Current measurement for each individual channel

• Drives one bipolar stepper motor over USB (max. 46V, 1.6A per phase)
• Noiseless operation of stepper motors
• Position, velocity and acceleration controllable
• Stepper resolution from full-step to 1/256-step
• Two configurable GPIOs for end-stops or similar

• Galvanically isolated switching of large AC or DC loads
  • For example: motors, pumps and lamps
• Bricklet controls Solid State Relays (SSR)
  • The offered SSRs can switch up to 380V/25A AC or 50V/80A DC
• PWM possible (dimming of lamps, control speed of motors)

• Measures sound pressure level in dB(A/B/C/D/Z) and ITU-R 468
• Measures spectrum with up to 512 bins and up to 80 samples per second
• Frequency range 40Hz to 40960Hz
• Noise floor 30dB, maximum 120dB

• Measures ambient temperature with 0.2°C accuracy
• Temperature range from -40°C to 125°C
• Output in 0.01°C steps

• Measures contactless object temperature from -70°C to 380°C
• Configurable emissivity
• Measures ambient temperature from -40°C to 85°C
• Output in 0.1°C steps (16bit resolution)

• 80x60 pixel thermal imaging camera
• Measurement range -10°C to 450°C
• Uses FLIR Lepton with radiometry and shutter
• High Contrast Image with 8.6Hz and 8 bit resolution (for display)
• Temperature Image with 4.5Hz and 16 bit resolution (for scientific calculations)
• Definable spotmeter with min, max, mean temperature measurement
• Automatic shutter control

• Measures temperature with a thermocouple
• Supports B, E, J, K, N, R and T type

Measures UV-A, UV-B and UV index

• Measure power, voltage and current up to 720W/36V/20A
• 1mW, 1mV, 1mA resolution over the whole range
• Bidirectional current measurement (e.g. charge/discharge)
• Configurable averaging and ADC conversion time