openHAB - RGB LED Bricklet

Warning

The openHAB bindings are still in beta, but the development was stopped.

This is the description of the openHAB API bindings for the RGB LED Bricklet. General information and technical specifications for the RGB LED Bricklet are summarized in its hardware description.

An installation guide for the openHAB API bindings is part of their general description.

Thing

UID:
  • tinkerforge:brickletrgbled:[UID]
Required firmware version:
  • 2.0.0
Firmware update supported:
  • yes
Channels:
Actions:

Channels

LED Color

The color of the LED.

Type:
  • Color - Only HSBType commands are accepted. Updating the brightness without changing the hue (e.g. by sending a PercentType) may fail.
UID:
  • tinkerforge:brickletrgbled:[UID]:BrickletRGBLEDColor
Read only:
  • No

Actions

Actions can be used in rules by creating an action object. All actions return a Map<String, Object>. Returned values can be accessed by name, sometimes the type deduction needs some hints, as shown below:

val actions = getActions("tinkerforge", "tinkerforge:brickletrgbled:[UID]")
val hwVersion = actions.brickletRGBLEDGetIdentity().get("hardwareVersion") as short[]
logInfo("Example", "Hardware version: " + hwVersion.get(0) + "." + hwVersion.get(1) + "." + hwVersion.get(2))

Basic Actions

brickletRGBLEDSetRGBValue(short r, short g, short b)
Parameters:
  • r – Type: short, Range: [0 to 255], Default: 0
  • g – Type: short, Range: [0 to 255], Default: 0
  • b – Type: short, Range: [0 to 255], Default: 0

Sets the r, g and b values for the LED.

brickletRGBLEDGetRGBValue()
Return Map:
  • r – Type: short, Range: [0 to 255], Default: 0
  • g – Type: short, Range: [0 to 255], Default: 0
  • b – Type: short, Range: [0 to 255], Default: 0

Returns the r, g and b values of the LED as set by LED Color.

Advanced Actions

brickletRGBLEDGetIdentity()
Return Map:
  • uid – Type: String, Length: up to 8
  • connectedUid – Type: String, Length: up to 8
  • position – Type: char, Range: ['a' to 'h', 'z']
  • hardwareVersion – Type: short[], Length: 3
    • 0: major – Type: short, Range: [0 to 255]
    • 1: minor – Type: short, Range: [0 to 255]
    • 2: revision – Type: short, Range: [0 to 255]
  • firmwareVersion – Type: short[], Length: 3
    • 0: major – Type: short, Range: [0 to 255]
    • 1: minor – Type: short, Range: [0 to 255]
    • 2: revision – Type: short, Range: [0 to 255]
  • deviceIdentifier – Type: int, Range: [0 to 216 - 1]

Returns the UID, the UID where the Bricklet is connected to, the position, the hardware and firmware version as well as the device identifier.

The position can be 'a', 'b', 'c', 'd', 'e', 'f', 'g' or 'h' (Bricklet Port). A Bricklet connected to an Isolator Bricklet is always at position 'z'.

The device identifier numbers can be found here