openHAB - Line Bricklet

Bemerkung

Zur Zeit ist nur die englische openHAB-Dokumentation verfügbar.

This is the description of the openHAB API bindings for the Line Bricklet. General information and technical specifications for the Line Bricklet are summarized in its hardware description.

An installation guide for the openHAB API bindings is part of their general description.

Thing

UID:
  • tinkerforge:brickletline:[UID]
Required firmware version:
  • 2.0.0
Firmware update supported:
  • yes
Channels:
Actions:

Channels

Reflectivity

The currently measured reflectivity. The reflectivity is a value between 0 (not reflective) and 4095 (very reflective).

Usually black has a low reflectivity while white has a high reflectivity.

Type:
  • Number:Dimensionless
UID:
  • tinkerforge:brickletline:[UID]:BrickletLineReflectivity
Read only:
  • Yes
Range:
  • 0 to 4095 (Step 1)
Parameters:
  • Update Interval – Type: integer, Default: 1000, Unit: ms, Min: 0, Max: 4294967295
  • Specifies the update interval in milliseconds. A value of 0 disables automatic updates.

Actions

Actions can be used in rules by creating an action object. All actions return a Map<String, Object>. Returned values can be accessed by name, sometimes the type deduction needs some hints, as shown below:

val actions = getActions("tinkerforge", "tinkerforge:brickletline:[UID]")
val hwVersion = actions.brickletLineGetIdentity().get("hardwareVersion") as short[]
logInfo("Example", "Hardware version: " + hwVersion.get(0) + "." + hwVersion.get(1) + "." + hwVersion.get(2))

Basic Actions

brickletLineGetReflectivity()
Return Map:
  • reflectivity – Type: int, Range: [0 to 212 - 1]

Returns the currently measured reflectivity. The reflectivity is a value between 0 (not reflective) and 4095 (very reflective).

Usually black has a low reflectivity while white has a high reflectivity.

If you want to get the reflectivity periodically, it is recommended to use the Reflectivity channel and set the period with the configuration of Reflectivity.

Advanced Actions

brickletLineGetIdentity()
Return Map:
  • uid – Type: String, Length: up to 8
  • connectedUid – Type: String, Length: up to 8
  • position – Type: char, Range: ['a' to 'h', 'i', 'z']
  • hardwareVersion – Type: short[], Length: 3
    • 0: major – Type: short, Range: [0 to 255]
    • 1: minor – Type: short, Range: [0 to 255]
    • 2: revision – Type: short, Range: [0 to 255]
  • firmwareVersion – Type: short[], Length: 3
    • 0: major – Type: short, Range: [0 to 255]
    • 1: minor – Type: short, Range: [0 to 255]
    • 2: revision – Type: short, Range: [0 to 255]
  • deviceIdentifier – Type: int, Range: [0 to 216 - 1]

Returns the UID, the UID where the Bricklet is connected to, the position, the hardware and firmware version as well as the device identifier.

The position can be 'a', 'b', 'c', 'd', 'e', 'f', 'g' or 'h' (Bricklet Port). The Raspberry Pi HAT (Zero) Brick is always at position 'i' and the Bricklet connected to an Isolator Bricklet is always as position 'z'.

The device identifier numbers can be found here