In the past we often had customers that asked us for suited motors and power supplies for our products. It wasn’t always easy for us to give good advice in that regard. It did take a while, but we now have different stepper- and servo-motors, a 24V/4A power adapter and miscellaneous other accessories in our shop.
24V/4A power adapter
The search for a suitable power adapter turned out to be pretty difficult. The power adapter should be able provide 24V with at least 4A. With this specification it is possible to power stepper motors as well as the Step-Down Power Supply. The Step-Down Power Supply has a maximum input voltage of 27V which is not exceeded by the 24V of the power supply. Another requirement was, that the power adapter is (out-of-the-box) usable with our standard black 2-pin connector. Most power supplies are only available with a barrel connector or as cable with center rail (24V) and outer insulation (GND). Both are not easy to use with our standard connector, we just need two stripped cable ends.
The last and most important requirement was of cause the quality of the output voltage. We tested many different power supplies and many (mostly cheap) power supplies had a ripple of up to 4V! We tested different power supplies in with regards to voltage stability, performance, short-circuit behavior and heating:
In the end we did find a 24V/4A power adapter that is still affordable. It had the most stable output voltage of all of the tested power supplies (+/- 500mV). It is short-circuit protected and it does not get super hot under full load. We ship the power adapter with two stripped cable ends. The cable ends can be inserted into our standard connector without any tools.
Stepper motors
We now have two stepper motors with fitting shaft couplings in our product range:
As a standard motor we offer a 200-step per revolution Nema 17 (42mmx42mm) stepper motor with a strong 0.43Nm torque and detachable cable.
The motor can be used together with the above mentioned 24V power adapter and only uses a per-phase current of 0.85A to reach the maximum torque. This means that our Stepper Brick remains cool during operation, an external cooling is not necessary. The 5mm shaft of the stepper motor has a flat section, such that the shaft couplings can’t slip.
As a second motor we have a 200-step Nema 17 stepper motor with high quality planetary gears with a gear reduction of 27:1.
For a full revolution you need 5400 steps of the motor. The motor can reach a torque of 5.94Nm and it can thus be used in applications where precision and/or high strength is necessary. The 8mm shaft of the motor also has a flat section and it can be connected to a 5mm or 8mm shaft with the offered shaft couplings.
Servo motors
Currently we offer two different servos from HiTec for the Servo Brick:
The HS-311 is a cheap standard servo with resign gears and torque of up to 35Ncm.
The HS-645MG does have 96Ncm of torque and it uses metal gears.
We will add more accessories to our shop in the future, stay tuned!